Originally posted by pnsji
so J,

the piston orientation is reverse?

With the way I mounted these calipers
the piston orientation would be in the correct sequence/order

which is the smaller piston should be on the rotor-entrance side of the caliper.
(the entrance side would be the upper piston
[img]http://groups.msn.com/_Secure/0RwDVAkgTGIMpobQ!3T*KKrKLl8ONzhmXh9NOf*fsfEOUuIrLQ iZVx5g7mjPc9s6mb3BN9!FY6UfYyGVUNsO1g6EyBCULKF1U5Bw DA*wtuTw/112-1203_IMG.JPG[/img]





I was going to sell this kit, and plannig to get Luwins AP kit off Jason , however since the AP kit is already spoken for.
Also after some research this AP 6-pot caliper Off Luwin's car won't even clear my 17"

I think I am going to give this a try one more time with 3mm spacer...before I decide it to sell it


Now where I can get a 3mm spacer..?


Anyone... ???

Regardz,