-
Anyone ever change the 1.8 mm leds in the center consol ?
Dosent seem too hard just the led on the s/w switch on the shifter and prnd
But I was thinking the 1.8 has this little plastic riser if I removed that could I run a 3 mm ? 1.8 is a little hard to find :/ keep in mind these are soldered down not regular bulbs
I'm thinking I should just retain the 1.8 as I have to do the dash esp ectect switches as well any input is appreciated
-
Bump I burned one out need knowledge now they seem to run off a extremely low voltage my test light reads a faint ground (I know the resistors are built in to the board
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules