Side moldings

[202rules]

Yesterday I removed the grey moldings that are on the 4 doors of the car, but I can't figure out how to remove the 4 remaining ones, the ones that are between each door and the wheel well, they're short in the back, long up front!

To remove the door ones, you had to open the door, there is one screw right at the edge of the door that holds the molding, after you unscrew that, you slide the molding to the side and it pops out. I haven't seen any screw in the back of the remaining four.

Anybody did this before?

Oh and the reason is I'm painting them black

[202rules]

Got it

No screws or anything, just prie em out, they clip using those white small pieces, those can still break easily though so better be careful.