Hi
well finally i decided to try to eliminate all the suspension noises and picked up the following parts.

Wheel Bearing Kit; Front Left/Right
Wheel Oil Seal; Front Left/Right
Steering Damper
Ball Joint; Front Lower Left/Right
Wheel Bearing Kit; Rear Left/Right

question1:
since my suspension has already 100k on it would it makes sense to replace all parts on my car with new parts (above list). I know my front and rear bearings are bad. front one is horrible complete ( i get clucking noises when turning and braking) while the rear makes noise as i start going over 60mph and gets louder. Or is it something u replace only if its broken. Will keeping lets say new bearing one side and old but not broken yet (probably in getting there) makes sense performance wise. or should i just get over and do all those things.

question2:
how long do usually parts from above list last on 1995 C36
(meaning if bearing goes out after 3months or so then i will replace with new only when fully broken)

question3:
Does anyone have manual or knows the torque specs when installing parts from above list.

thanks