Excellent HowTo! Thanks!!

Just one tip regarding Step #8:

Originally posted by BBW
8. The 'Skeleton' should be ready for removal, on each side of the bumper 2 plastic plugs hold it in place. One at the top, the other at the bumper.



Be careful! Make sure you have the correct bottom plugs and not the plugs which hold the 'Lip' of the bumper in place! See picture:


Unclipping them takes strength and time, if done correctly they shouldnt break!


[/B]
Each 'plug' (actually called Rivets) has a plastic post through the center that expands the rivet's 'fingers'. Use a small punch, or even a tiny screwdriver, and push/tap out the post toward the flange of the rivet. Then the remaining portion can be pushed out also without risk of breaking them.
If you do, original part # is 114 990 01 92, but has been replaced a few times to currently 001 990 16 92.