P0302

[FreeStyler]

OK just got a reading: The only code that came up was P0302.

Cylinder 2 Misfire Detected

So,
do you guys think this would help:
Checking the rubber boots?
Replacing spark plug and wires?
And worst case scenario change coil or injectors?

Thanks guys

UPDATE:
Spark plugs look good, rubber boots not broken must be something else then:confused:

[Denlasoul]

Switch the coil packs (swap #2 for #3) and see if the misfire comes up on #3. If it does, then you coil pack is bad.

[aintME]

Originally posted by Denlasoul
Switch the coil packs (swap #2 for #3) and see if the misfire comes up on #3. If it does, then you coil pack is bad.

i've also heard that the wires go bad pretty often on the MB cars :( try replacing those, at least it wont cost the arm and a leg the coil packs do.

[1995c280]

the wires usually go bad on the 112 and 113 engines only. so you don't need to worry about them unless you got water down there. if you already switched the coil and the misfire stayed on the same cylinder, just replace the spark plugs and the boots like you originally intented. the plugs are cheap and the boots under the coils can be bought seperate. you don't need the whole wire set unless you haven't replaced the wires in a long *ass* time. then it might be a good idea.

i replace wires, boots, and plugs every year but i an very anal when it comes to maintance on my cars!

Jason

[jnenad16]

Originally posted by 1995c280
i an very anal when it comes to maintance on my cars!

yeah, I wish my girl would get anal once in a while:(

:D :D :D :D :D :D :D

nenad

[mazdalowandslow]

oh man.. that was totally unneeded.. hahah ^

[1995c280]

Originally posted by jnenad16
yeah, I wish my girl would get anal once in a while:(

:D :D :D :D :D :D :D

nenad

LMAO, haha!!!!!!!!!!!!!!