Cru328prod
04-16-2007, 05:40 PM
i know this may be shitty looking but hey it gets the job done lmfao
Tools Needed:
2 Flathead Screw Drivers (small and big)
1 Finger
2 Hands
Zip Ties
Drill with Drill Bits
http://img.photobucket.com/albums/v129/icangivit2uma/IMG_0407.jpg
http://img.photobucket.com/albums/v129/icangivit2uma/IMG_0408.jpg
Take the Big flat head and pry the mesh open
http://img.photobucket.com/albums/v129/icangivit2uma/IMG_0409.jpg
http://img.photobucket.com/albums/v129/icangivit2uma/IMG_0410.jpg
http://img.photobucket.com/albums/v129/icangivit2uma/IMG_0411.jpg
Now open up your trunk and look at the speakers
http://img.photobucket.com/albums/v129/icangivit2uma/IMG_0413.jpg
Now theres 2 sets of tabs you have to push them in
http://img.photobucket.com/albums/v129/icangivit2uma/IMG_0414.jpg
http://img.photobucket.com/albums/v129/icangivit2uma/IMG_0415.jpg
http://img.photobucket.com/albums/v129/icangivit2uma/IMG_0416.jpg
Then Pull it out but make sure you disconnect everything
http://img.photobucket.com/albums/v129/icangivit2uma/IMG_0417.jpg
Now you have to pry open the speaker from the bracket, and either glue or do what the pics says, and just reverse the steps, Sorry i wish i've don't this before i put the AM speakers in. I hope someone comes up with one better
Tools Needed:
2 Flathead Screw Drivers (small and big)
1 Finger
2 Hands
Zip Ties
Drill with Drill Bits
http://img.photobucket.com/albums/v129/icangivit2uma/IMG_0407.jpg
http://img.photobucket.com/albums/v129/icangivit2uma/IMG_0408.jpg
Take the Big flat head and pry the mesh open
http://img.photobucket.com/albums/v129/icangivit2uma/IMG_0409.jpg
http://img.photobucket.com/albums/v129/icangivit2uma/IMG_0410.jpg
http://img.photobucket.com/albums/v129/icangivit2uma/IMG_0411.jpg
Now open up your trunk and look at the speakers
http://img.photobucket.com/albums/v129/icangivit2uma/IMG_0413.jpg
Now theres 2 sets of tabs you have to push them in
http://img.photobucket.com/albums/v129/icangivit2uma/IMG_0414.jpg
http://img.photobucket.com/albums/v129/icangivit2uma/IMG_0415.jpg
http://img.photobucket.com/albums/v129/icangivit2uma/IMG_0416.jpg
Then Pull it out but make sure you disconnect everything
http://img.photobucket.com/albums/v129/icangivit2uma/IMG_0417.jpg
Now you have to pry open the speaker from the bracket, and either glue or do what the pics says, and just reverse the steps, Sorry i wish i've don't this before i put the AM speakers in. I hope someone comes up with one better