How to swap out Rear Seat light

[sensoryx]

Hii

I've sent out a couple PM to some members, but havent gotten a definate answer yet so I figured id ask the public forums.

How do I remove the plastic so I can swap in the LED light. I feel like I can pry it open, but im not sure if its the correct way, im scared its going to snap and break.
Whats the correct way of doing it? Is there some kind of hinge?
Thanks!

[kevinzorz]

.

[sensoryx]

Cool Thanks ill give it a try
but how come the words "be careful"? Too much force will break it? :confused:

[kevinzorz]

just becareful :)

[Section 8]

lol im not gonna do it now hahahahah

[sensoryx]

Originally posted by Section 8
lol im not gonna do it now hahahahah

edit: dont listen to meee
refer to post below haha

[kevinzorz]

dont just pry down, using a flathead screwdriver, push in.. like towards the bulb. the light-covers have little clips on each side that pop in. Same for the inside of the trunk, wedge your screwdriver in the side, and push in. For the license plate lights, you use your screwdriver and push in the little tab on the side, dont just
pry them out, you'll break them like that.

[sensoryx]

thanks kevinzorz, couldnt have done it without u;)