View Full Version : auto switch not working!
svt ricco
07-10-2007, 10:26 PM
ok, so now i have installed my new head unit,everything sounds so different and i'm so loving it...here's the problem,when try to put up my window manually, it goes up or down, but when i push the automatic switch, it doesn't work, please help!! thanks in advance
make it go up and down a few times without auto n then try it again. this happens to me everytime i disconnect my battery.
svt ricco
07-10-2007, 10:39 PM
ok,will try it now!!! thanks for your reply
svt ricco
07-10-2007, 11:02 PM
still the same man,what else do i have to do?
OCKlasse
07-10-2007, 11:20 PM
Originally posted by svt ricco
still the same man,what else do i have to do?
it will come back...it always does
svt ricco
07-10-2007, 11:30 PM
what if it didn't? should i take out the battery termiinal again? this shouldn't be happening since it's just all plug and play right?
make sure they go all the way up and all the way down without stopping.
Logic
07-11-2007, 06:51 AM
if you read the manuel in your car there is a section for your window learning...most time when the battery is disconnected you have to reset your windows and sun roof... most time when you roll windows up and down it learns its self but you have to do the manuel roll up and down.....same with the sun roof:cool:
svt ricco
07-11-2007, 11:33 AM
ok, thanks for your replies!! fix everything this morning, now everything works just fine!! sub box and lowering springs are the last mods, will post pics soon
sensoryx
07-11-2007, 12:29 PM
Originally posted by svt ricco
ok, thanks for your replies!! fix everything this morning, now everything works just fine!! sub box and lowering springs are the last mods, will post pics soon
so how did you fix it in the end? just roll the window up and down manually?
svt ricco
07-11-2007, 03:53 PM
close the windows, press up for 2 secs,voila!! you have to do this on all 4 windows
Kropf
07-11-2007, 11:39 PM
Pg. 76 of my 1999 C230/C280/C43 Owner's Manual states:
Synchronizing Sliding/Pop-Up Roof
If the power supply was interrupted (battery disconnected or empty), or if the sliding/pop-up roof is blocked during closing/opening procedure, the system has to be synchronized.
To do so, turn electronic key in steering lock to position 2, move and hold switch in direction (3) (up) until the sliding/pop-up roof is completely raised at rear, and hold for additional 1 second.
And pg. 78 states:
Synchronizing Power Windows
If the power supply was interrupted (battery disconnected or empty), the windows cannot be opened or closed by the Express feature.
To resynchronize the Express feature, press ^(up) side of power window switch until the window is completely closed and hold for additional 2 seconds. Repeat procedure for each window.
The automatic full opening and closing procedure of the windows should now be restored.
(I'll quote it again: "The only thing I learned from my computer science degree... was to read the manual." :-) )
Powered by vBulletin® Version 4.2.5 Copyright © 2025 vBulletin Solutions Inc. All rights reserved.