dakarch
07-19-2007, 12:38 PM
I have a 1999 C230. I went to add a little r134 to it the other day and ran into an odd problem.
I have a set of 134 manifold gages. I believe I correctly located the high and low pressure access points (low on the back of the compressor and high under the grille by the evaporator).
I would expect these connections to be standard for r134; however, the low pressure side (back of compressor) is smaller than my low pressure manifold coupler and the high pressure side is bigger than my manifold.
Do I need a special tool/adapter?
I have a set of 134 manifold gages. I believe I correctly located the high and low pressure access points (low on the back of the compressor and high under the grille by the evaporator).
I would expect these connections to be standard for r134; however, the low pressure side (back of compressor) is smaller than my low pressure manifold coupler and the high pressure side is bigger than my manifold.
Do I need a special tool/adapter?