PDA

View Full Version : Could this be True?


Cru328prod
07-26-2007, 11:06 AM
Repairing your MAF?


http://cgi.ebay.com/ebaymotors/MAF-SENSOR-MASS-AIR-FLOW-Mercedes-SLK-c230-Kompressor-X_W0QQcmdZViewItemQQcategoryZ33557QQihZ002QQitemZ1 20144997881QQrdZ1QQsspagenameZWDVW
nhmercracer
07-26-2007, 12:37 PM
Yes, and this simple... Remove MAF. Spray with CRC MAF cleaner. Reinstall.

There you go. You can Paypal me $55.00 if you wish.

Sean
xvvvz
07-26-2007, 01:46 PM
Somebody in another forum posted that one of these instruction sets just instruct you to soak your MAF in a baggie full of rubbing alcohol, then shake vigorously, then allow to dry.

Go with the CRC for $6 at Pep Boys.
Cru328prod
07-27-2007, 04:25 AM
LMFAO ARE YOU GUYS SERIOUS. the guy a autozone gave me this t body cleaner, and it said MAF safe........i sprayed it......and it started acting werid. sometimes the supercharger wouldn't start.
xvvvz
07-27-2007, 07:39 AM
Throttlebody cleaner is a no-no. It is not formulated for MAFs. MAF cleaner has to be formulated to not attack any of the components and it can't leave any residue. Most TB cleaners have a lubricating component which would be bad for an MAF.
hvmercy
07-27-2007, 07:49 AM
Originally posted by xvvvz
Throttlebody cleaner is a no-no. It is not formulated for MAFs. MAF cleaner has to be formulated to not attack any of the components and it can't leave any residue. Most TB cleaners have a lubricating component which would be bad for an MAF.

:werd:
nhmercracer
07-27-2007, 07:58 AM
Gentlemen,
I was not entirely serious with my last post. To me the Ebay auction is a scam. I attempted to get the point across that if you were to clean your MAF sensor, there are products from reputable companies for this purpose. I have used CRC products with great success in the past. A cleaner of this type must leave NO residue as it dries. Try cleaning a greasy surface with alcohol and you will usually see a greasy residue as the alcohol dries
RemoLexi
07-27-2007, 08:47 AM
new one always best.
alphanumeric
07-27-2007, 11:54 AM
yah.. usually you will end up needing a new MAF.. but hey.. try the cleaning method first, it cant hurt
Cru328prod
07-28-2007, 03:38 AM
i don't think its too late to clean it with some crc? car runs fine, no cheak engine light nothing,
nhmercracer
08-14-2007, 03:01 AM
If you haven't done so already, use the CRC MAF cleaner on your sensor. Should remove the film left by the TB cleaner.
I have used this product on several vehicles with no problems.