PDA

View Full Version : Engine Swapping in 6hrs



Cru328prod
11-02-2007, 12:02 PM
http://img.photobucket.com/albums/v129/icangivit2uma/Image61.jpg

New M111

http://img.photobucket.com/albums/v129/icangivit2uma/Image62.jpg

Supercharger

http://img.photobucket.com/albums/v129/icangivit2uma/Image63.jpg

:( I wanted to cry for a lil

http://img.photobucket.com/albums/v129/icangivit2uma/Image64.jpg

Had to use the it to screw in the motor mounts

http://img.photobucket.com/albums/v129/icangivit2uma/Image65.jpg

Connecting everything back together



at 1st it start off pretty werid....but i forgot there wasn't enough gas inside.........the biggest pain in the ass was the timing.....among other things..........i had to take a socket wrench to the crank, turn it......and then put a bolt, tighten. and turn again for like 6 times


I've been driving it for a while now, but if im at a dead stop in D it starts to shake really bad.....when i put it in N the shaking stops............anyone have any ideas?

Logic
11-02-2007, 05:36 PM
well i had a thing like that with my nissan and as soon as i put it in drive it would shake. when you put it in drive it puts a load on the car and cause the engine to idle a little lower which caused it . i increased the idle a bit more and it went away..i m not saying thats what it is but just throwing a idea out there by the way i thought mercedes was fixing your stuff under warrenty?

enawazh
11-02-2007, 06:36 PM
First of all job well done...

i had similar rough idle problems with a mazda and a supra swap. my suggestion would be to check your idle and motor mounts .. just make sure all your mounts and lower supports are tight...
Good luck

RemoLexi
11-02-2007, 08:25 PM
what happen to your first M111 motor ??

Len013091
11-02-2007, 08:45 PM
My guess is the nitrous made it splode?

Cru328prod
11-03-2007, 04:01 AM
haha NOS blew the tranny......water bent the rods.......stupied water WE DONT EVEN NEEED WATER:mad: lmao

i hydrolocked:(


haha not under warrenty anymoreeeeeeeeeeeee

someone told me it was a "IAC"......i didnt he was talking about then it poped in my head idle air control, but i don't know where that isssss in the car. it stalled on me twice

Nitrogenbalance
11-03-2007, 05:57 AM
Originally posted by Cru328prod
haha NOS blew the tranny......water bent the rods.......stupied water WE DONT EVEN NEEED WATER:mad: lmao

i hydrolocked:(


haha not under warrenty anymoreeeeeeeeeeeee

someone told me it was a "IAC"......i didnt he was talking about then it poped in my head idle air control, but i don't know where that isssss in the car. it stalled on me twice

Hydrolocked?? Bent rod? Where you running your intake at the ground while driving through 8in puddles??

xvvvz
11-03-2007, 07:15 AM
So did you just buy a used engine, a rebuilt engine or what? I am guessing that in six hours you didn't rebuild your original engine.

Have you had a look at your engine and trasmission mounts to see if they are correctly tightened and not collapsed to see if that could be the cause of the vibration?

Proven Guilty
11-03-2007, 08:26 AM
tripple check your vacuum lines if there is a rough idle when you stop. also, check compression since it doesn't look like a brand-new engine.

Cru328prod
11-05-2007, 03:36 AM
Originally posted by Nitrogenbalance
Hydrolocked?? Bent rod? Where you running your intake at the ground while driving through 8in puddles??

well since i have no splash guard anymore from the stupied tow truck.........it sucked up the water like a straw

Logic
11-06-2007, 07:56 AM
Originally posted by Cru328prod
haha NOS blew the tranny......water bent the rods.......stupied water WE DONT EVEN NEEED WATER:mad: lmao

i hydrolocked:(


haha not under warrenty anymoreeeeeeeeeeeee

someone told me it was a "IAC"......i didnt he was talking about then it poped in my head idle air control, but i don't know where that isssss in the car. it stalled on me twice

ok not to rub it in again but weren't you telling me you didnt need a aem bypass valve ?????????????LOL ok bow down to me and say sorry :devious:

Cru328prod
11-06-2007, 10:00 AM
you don't need a aem bypass if you have your splash guards lmao...........but even then depend on the condition your bypass won't do much it'll still suck up water, but it won't drown the cyclinders as bad to cause major damage........

Logic
11-06-2007, 11:43 AM
just bow down is all i m asking;) LOL

Cru328prod
11-06-2007, 01:19 PM
oooh yes u final admit u like 20yr olds bow'ing down to u LMFAO

Logic
11-07-2007, 07:49 AM
yes i do especially when the 20 year old girls like you LOL j/k