how to remove 90 bend between maf and tb

[expo5.0]

need to figure out how to remove this and how to 'clock' it sideways in order for it to fit my SC installation.

thanks a ton

-drew

[Logic]

is there i link you forgot to put in?

[expo5.0]

no- i'll snap a picture

also, i need the belt routing - but i bet only nitrogenbalance can help

[expo5.0]

this piece-

it has a clip on the top which looses the top half, but the bottom clips won't release

http://i138.photobucket.com/albums/q243/teamsilence1/902.jpg

http://i138.photobucket.com/albums/q243/teamsilence1/901.jpg

[SLAMMED_C]

the clips are the same top and bottom. its a tab that needs to be pressed down (for the bottom) to release it. then slide the bend towards the firewall slightly and up. but be careful to not get the bottom tab on the bend caught on anything when removing it.. it will break. then you need a new one. air could seep in and you will get self adaptation codes for being at their limit.

[expo5.0]

figured it out- my lower clips were VERY tight.

i'm going to have to remove those clips and use a silicon coupler in order to angle it the way i want to.

i have no idea how else it is supposed to be done with the sc kit- but that will work fine