PDA

View Full Version : fuse box help



Koolvin
01-28-2003, 10:44 AM
how do you get this:

http://193.63.6.63/koolvin/benz/puddle/bladefuse.jpg

into

http://193.63.6.63/koolvin/benz/puddle/fuseb.jpg

sparcus
01-28-2003, 10:47 AM
wdf!!!!! ahahhahahah u glue it vin ;)

-kok

mike c200
01-28-2003, 01:21 PM
Hi vin

we need steve here he knows how to do that by a new style fuse box

Greetingz,

Mike

nokia8860
01-28-2003, 02:07 PM
read the article for folding mirrors in the features section.

basically you pop out the section you want. It is held in by little clips. Just spread it till it pop out back.

http://www.club202.com/features/w210_mirrors/file005.jpg

*section of fuse remove. Just push down and it pops out*

Then you look behind it and in the section you want you will see A B C D. Plug it in and it will snap to place.

Koolvin
01-28-2003, 11:13 PM
I did read that Joey :p but I am still a bit unclear, let me explain what I am trying to do:

OK...

I need to get a switched power into my engine bay from the ignition (5 amps).

I know the best way is the way MBenzNL would do it and that is OEM ie into the fuse box. (I have ordered the contact pin/plug already)

1. I still couldn't manage to push the contact pin into the hole when I was wiring puddle lights so I need you to explain very quickly what I have to release once the fusebox is out, to push the contact pin in there.

2. which hole do I need for switched ignition?

3. how do I run this new wire from the fuse box to the otherside of the engine bay without drilling my fusebox?

Thankyou so much, I need to get my fueling sorted and these wires are for a additional ECU that controls a 5th injector to supply extra fuel I need.

MBenzNL
01-29-2003, 05:56 AM
The red inserts...these are stuck in the bottom of the fusebox to lock the contactpins...you need to slide the red inserts to the side (only a little...which goes easy and only into 1 direction)...the rest was answered per mail ;)

greetingz,