View Full Version : CEL Light
HRC280
06-08-2008, 04:55 PM
I had my smog check fail because CEL would not come on in position 2. Everthing else measured out ok. Smog tech told me to check bulb, which I did and found that it was burnt out. I have replaced it but now the CEL light stays on while running, does not come off after all others go out. Car runs fine. Is it a need to reset this after changing out the bulb?
Proven Guilty
06-08-2008, 04:58 PM
they tech probably left your CEL toggled on if they were checking functionality of the ECU.
xvvvz
06-08-2008, 07:03 PM
If you have time, I would go by Autozone and borrow their free OBD II code scanner and scan the car just to make sure there isn't a code that the emissions guy didn't see. I am guessing the light burned out due to being on so long, so that would indicate and error back then plus the fact it is still trying to illuminate now.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.