how do you remove partition panel - pictorial

[ejagz]

click at this for the picture (http://www.detali.ru/cat/oem_mb2.asp?TP=1&F=202029&M=112%2E920&GA=722%2E606&GM=717%2E465&CT=F&cat=44V&SID=83&SGR=180&SGN=05)
i am trying to replace #65 from this picture.

in order to do that i need to remove partition panel green arrowed to reach grommet (#65 in above picture) red arrowed. please send me instructions to remove partition panel in 95 c280

click at this picture to see green and red arrows (http://www.satrattan.com/mb/rad/rad3.jpg)

[Cru328prod]

aw dude i've never seen that partition panel removed before...i always thought it was built in...i know the rubber piece comes off

[c280nz]

i thought u are trying to remove 35 not 65,
just start undoing and pulling at parts to try and get it apart

[ejagz]

c280nz, i have ordered 65
will update

[Pagz]

-Remove anything obstructing the upper half of the sound deadening at the rear of the engine bay.

-remove sound deadening

-Undo screws and remove engine bay divider

-remove #65,Install new #65

-reinstall everything.

If you are unable to see how to do this then a workshop is your best choice.

[ejagz]

i consider that i am very close to replacing the grommet. someone please tell me what is the technical name of this structure (http://www.satrattan.com/mb/rad/rad4.jpg) i need to remove this thingy.

[ejagz]

hurray, mission accomplished
part 202 832 11 15 heater pipe line cost $4.32 including tax
labor cost $0
time spent about 3 hours
mucho thanks