View Full Version : No washer fluid
Logic
06-19-2014, 12:24 PM
Been doing things for my new c43 , the relay for intermitted power seats was simple as I pulled the relay cleaned contacts and it seems to be working as the seats so far haven't stopped working replaced a bulb or 2 but I noticed my fluid motor isn't working and the fuses are good . Any one replace these as I see two pumps . One inside the tank and another out side . Was trying to see if my headlight wipers were working and notice no fluid :/ press the switch and no noise or hum out of it .
Logic
06-20-2014, 05:59 PM
23 views and no answer
benz4life
06-26-2014, 01:11 PM
I did replace my windshield motor pump twice in my old 97 C230 , 1st was about 30 usd , 2nd one a cheaper china version 9 usd. came with a rubber too, but still works . Very easy DIY. C230 only has one pump, but I was wondering if measuring with the Ohmmeter the resistance should be zero , or infinite? I just measured the old one that's supposed to be bad and its zero - continuous circuit..
http://i.imgur.com/vhXEnQG.jpg
I only see one pump, no 66 , which one is the 2nd one?
Sulaco
06-26-2014, 02:42 PM
yeah pumps fail a lot on virtually all MB's. I've had one fail on 2 of my 3 w202's and on my w124.
Logic
06-28-2014, 04:08 PM
so i m assuming 66 is the pump ? what is 62 than
Logic
06-28-2014, 04:11 PM
mine looks like the 2nd so i assuming 66 is the pump ?what is 65
Sulaco
06-29-2014, 04:58 AM
66 is pump. 62 is level detector I think. 65 is just rubber seal for level detector
Logic
06-29-2014, 08:29 AM
So the pump just twists out and new one is pushed in ?
benz4life
07-02-2014, 06:45 AM
So the pump just twists out and new one is pushed in ?
That is correct sir
Powered by vBulletin® Version 4.2.5 Copyright © 2025 vBulletin Solutions Inc. All rights reserved.