vaspen
12-09-2015, 02:11 PM
Dosent seem too hard just the led on the s/w switch on the shifter and prnd
But I was thinking the 1.8 has this little plastic riser if I removed that could I run a 3 mm ? 1.8 is a little hard to find :/ keep in mind these are soldered down not regular bulbs
I'm thinking I should just retain the 1.8 as I have to do the dash esp ectect switches as well any input is appreciated
But I was thinking the 1.8 has this little plastic riser if I removed that could I run a 3 mm ? 1.8 is a little hard to find :/ keep in mind these are soldered down not regular bulbs
I'm thinking I should just retain the 1.8 as I have to do the dash esp ectect switches as well any input is appreciated