PDA

View Full Version : Code P1525



pnsji
12-23-2003, 10:13 AM
P1525 - Crankshaft solenoid sensor

Has anyone had this problem?

714guy
12-23-2003, 10:17 AM
Originally posted by pnsji
P1525 - Crankshaft solenoid sensor

Has anyone had this problem?

how does you car run?? once my crankshaft sensor got wet and it wouldn't let me rev pass 2K, all i did was blow it dry to get it back to normal. I didn't get any CEL tho. so i dont know if its any help.

good luck

J Irwan
12-23-2003, 10:32 AM
Originally posted by 714guy
how does you car run?? once my crankshaft sensor got wet and it wouldn't let me rev pass 2K, all i did was blow it dry to get it back to normal. I didn't get any CEL tho. so i dont know if its any help.

good luck

Jason
do you have any idea where this crankshaft sensor located..

I couldn't find it on the EPC..


if you have picture it would be even better :)



Regardz,

pnsji
12-23-2003, 12:25 PM
I got CEL and It looks like the sensor and also wiring harness.
This happend after the valve cover gasket fix and also timing chain gasket and seals fix.

The SFMB are fixing it at the moment.....

Edit: my car runs okay, but since CEL is on, it is in retarded mode(AKA super slow)

714guy
12-23-2003, 01:06 PM
Originally posted by J Irwan
Jason
do you have any idea where this crankshaft sensor located..

I couldn't find it on the EPC..


if you have picture it would be even better :)



Regardz,

Its in a very akward place, but you look straight down where your oil filter is, theres a sersor that goes into the tranny and thats it. It even harder to unplug it you can only do it from the bottom of the car and have yout hand twist in akwards positions to get it out.

The reason my sensor got wet is b/c it was leaking coolant from above where there is that spout that goes thru the firewall, so it dripped all over the tranny and the sensor.

pnsji
12-23-2003, 05:15 PM
so the service advisor did not tell me the correct things.
It is the solenoid for a magnet on top of the cam.
The purpose of this magnet is to adjust the timing.
Apparently the magnet is broken and need to be replaced.