Any pic of installed Speedy's Camber arms?

[MBATF]

OK...this sounds very stupid...but Do i swap out the old rear Camber arms and replace with Jeff's?

Cuz i tried it yesterday and the oem rear camber arms' bolt was too big to go through the Hem-joint of Jeff's camber arms.... any input?

insalled pic would be nice

[nokia8860]

http://www.joeyandmona.com/albums/speedybenz-c43/DSC00649.sized.jpg

[speedybenz]

Was the problem area on the side with the hub? Or on the subframe ide as in Joey's pic?

Jeff

Let me know and I will send you new inserts.

[MBATF]

Originally posted by speedybenz
Was the problem area on the side with the hub? Or on the subframe ide as in Joey's pic?

Jeff

Let me know and I will send you new inserts. the inner end of the subframe...the bolt is too thick to fit through the joint.....

[speedybenz]

I have found in rare cases that the subframe bolt is a very big diameter bolt, even larger than the bolts I purchased from MB to use as a guide for the hole size and much larger than the avg 12mm bolt.

You can take a round file and open up the hole in the inserts or I can send you new inserts opened up to accomadate the large stock bolts.

Jeff