PDA

View Full Version : Pulley install on C230k



MrSpace
10-20-2004, 07:33 AM
http://www.bnzsport.com/forums/index.php?showtopic=14033

Etienne

b29Pb
11-18-2004, 11:08 PM
very very good and informative article..
a guy like you can help all the people out there
who needs more power but got no money...

including me..hehehe..thanxXx once again..
are you still under warranty?? cant wait
till you go wild..hehehe..any other mods
you have done to increase your car`s power??

MrSpace
11-19-2004, 06:50 AM
I was about to get a performance exhaust from Cklasse (high flow cat, performance exhaust, custom piping) but my finances are really low now because I am in court for a job I did not get as an engineer and loosing a lot of $ right now.

I'm also waiting because Cklasse told me that a too rich A/F ratio will kill the cats and I want to make sure mine is right before doing it. I think it's not too rich good because I get almost same fuel economy with the pulley even if I have lots more performance.

Other steps are chip upgrade to help the throttle response

and I'm trying to get a way to put a cone filter with bypass valve on the car, removing the supercharger clutch and putting a little more boost (if I don't sell the car for the new SLK before).

For warranty, the install is pretty stealth, apart from the relocated MAS and new belt which is not OEM you can't really tell the difference. If something breaks engine-wize, I'm putting back the stock pulley in less than one hour before going to the dealership;) The ecu is the only thing tat bugs me so I might just not change it to be safe with the warranty

Etienne

b29Pb
11-19-2004, 12:20 PM
mind if u post your engine pic??

well regarding the knowledge you have..
mind helping me out??

my car is a M/T c180 `94 and i want to make it
go crazy..not in a dragstrip..more to daily and
long-run setting..because i prefer highway rcg..
hehe..noise or pollution level is not a prob..
you know those restriction stuff..it doesnt apply
for me...help me please..thanks..