Todd,

I am waiting to recieve the rod end pieces and then I can start sending out the arms. I hope to have some complete by mid next week.

Sorry for the slight delay. It just takes a little time in the garage machining the inserts.

On the C43 you will have to jack up the rear and remove the wheel. You will need a 19mm and 18mm wrench or socket to remove the inner bolt and nut. The outer bolt takes a 12point, 12mm socket and 18mm wrench.

Once the bolts are loose just pull up slightly on the hub and they will slide out.

Then adjust the camber arm to the same length as your old arm and finger tighten the jam nuts. Slide the arm into place and put the bolts in the holes. Install the nuts and tighten everything down. Then lastly tighten the jam nuts with a wrench. Your done. Go do the other side.

Jeff