-
MB,
Thanks for the quick response. You are right about the connector. It is oval and has 4 blade terminals coming from the headlight housing. I was thinking that if it is not possible to get this connector that I would use those female spade connectors, and put some sort of sealant around the wires. Not only would this prevent any water issues, it would also prevent the wires from rattling off.
Thanks for taking the time to check to see if there are any part numbers available. I appreciate it.
As far as the trim pieces underneath the headlight are concerned, what is the difference between the pre and the post update?
Thanks again,
Ian
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules