1996 c280 cam cap bolts

[taz069]

Morning all. Having trouble finding the proper bolts for my 1996 c280 104. Found these #'s in benz world. Cam cap bolt #120-990-02-21, and gear bolt # 120-990-02-4, They are for a 1995 c280. Will these work with mine. They are located at parts.com. But not in the engine break down chart. Can only be found by entering the part # manually. Are the motors the same for a 95@96 c280? Being the inline 6. Thanks All.

[SD202]

I to have a 96 C280 and yes the 95s do in fact use an M104 Inline 6 Although i do believe obd2 wasnt introduced yet so the 95s are presumably obd1

[anf6789]

my 94 C280 is OB2, it wasnt required until 96, though some companies started earlier.

[SD202]

my 94 C280 is OB2, it wasnt required until 96, though some companies started earlier.

You're 94 is "obd2 compliant" not full OBD2 that was not required/ fully implemented until 1996. 95 was the transition year for W202 to full obd2. But you're codes can be read with the obd2 scanner as i believe being partial obd2 you have the 38 pin diagnostic port under the hood as well as the OBD2 port under the dash correct ??

[wichipong]

my 95 is obd2

[anf6789]

never seen the 38 pin diag port, where would that be located, i always use the ob2 under the dash.

[SD202]

never seen the 38 pin diag port, where would that be located, i always use the ob2 under the dash.

It is under the hood on the right hand side of the car. Located near the OVP in my car I believe you have the k40 relay there instead right in front of the ECU and cruise control modules.

[strictlyspeakin]

Yeah, I believe you are correct. We early birds are not truly obd2 just close. For most purposes, one would never notice a difference. There are some things which are not available or supported when using a quality scanner. SD202 might be talking about that circular plug up there. Haven't counted the pins though.