Results 1 to 6 of 6

Thread: 722.6 upgrades?

  1. #1
    Senior Member
    Join Date
    Feb 2013
    Location
    biglerville pa
    Posts
    783

    722.6 upgrades?

    Was looking and I found these guys work on the Dodge variant of the 722.6
    Opinions? Any possible in site on them ?
    My car shifts waaayyyy too slow for my taste

    http://www.hotrod.com/how-to/transmi...ssion-upgrade/

  2. #2
    Junior Member
    Join Date
    Dec 2014
    Location
    London, UK
    Posts
    15
    You could fit an Ole controller, but you'd need a stand alone ecu for the engine with that. The ole controller lets you adjust line pressure which is what affects shift firmness.

    Or you could fit a 722.6 from the V8 or v12 AMG, you would just have to swap the bell housing if you have an inline engine in your W202, otherwise your stock bell housing will be fine. The AMG V8 & 12 722.6's have loads more clutch plates so they are much stronger but actually I'm not sure if the shift firmness would change as you would have the same line pressure..

  3. #3
    Senior Member
    Join Date
    Feb 2013
    Location
    biglerville pa
    Posts
    783
    I wouldn't doubt that the s class cars ecu is set to shift harder

  4. #4
    Junior Member BlownC43's Avatar
    Join Date
    Dec 2013
    Location
    Palmdale, CA
    Posts
    16
    I upgraded my w202 722.6 to the 722.643 due to the hp increase

  5. #5
    Any write up about the swap you did?

  6. #6
    In Charge
    Join Date
    Dec 2002
    Location
    Left Lane
    Posts
    4,533
    722.6 has limits of close to 700hp/tq, your stock tranny could easily withstand the extra power from the HPS system. Which car uses the 722.643?
    1998 C43
    1994 C280 (Retired)

    "Simplicity is the ultimate sophistication." - da Vinci

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •