Silicone Elbow + Crankcase vent bypass complete!!

Hey guys.

I have finished the silicone elbow project finally. You guys have seen the old pictures but now I finally finished the crankcase vent bypass as well. What this does is it makes sure that all 100% of the air entering the engine passes through the Air sensor so the sensor can accruately gauge exactly how much air is coming in and as a result it improves your Air Fuel Ratios.

The Crank case vent is an emissions deal and it essentially is a controlled vaccum leak, it makes all the oil vapors go back into the engine and reburn them. This however also is air that does not pass through the MAS and as a result it can cause lean conditions. By putting a K&N breather on there instead of routing it back to the intake it can be filtered out and the filter air can then pass out into the atmoshpere. In addition, this also improves overall running of the car as well.

Performance: I honestly was not expecting any gains from this but wow was i pleasantly suprised. The car is NO longer knocking or running lean and torque had jumped up a significant substantial amount. in addition the car idles better now (though at first it will idle rough the first 10 seconds as the car gets used to the new extra air coming in at idle). The mid range power is significantly improved and now my EGR problems went away (go figure). So this solved MANY of my problems. and now I should be getting a dyno very soon after I have my custom high flow midpipes installed, and I am expecting serious gains. Anyways here at the pics, enjoy